| Mustang Club of Maryland http://mustangclubofmd.com/phpbb/ |
|
| Removing the steering wheel http://mustangclubofmd.com/phpbb/viewtopic.php?f=6&t=889 |
Page 1 of 1 |
| Author: | gtvert01 [ Sun Mar 18, 2007 7:44 am ] |
| Post subject: | Removing the steering wheel |
Has anyone removed their 99+ Steering wheel? Dan gave me his FR500 wheel to put on my Mustang. I tried the puller they rent from AutoZone it screws into two holes in the steering wheel and then you crank down on a bolt in the middle to pop it off. When I tightened it up it stripped the threads on those two holes. I have a manual for my F150 and it says to use a two claw puller for that steering wheel. Anyway just wondering if anyone has done it and had success and what you used. |
|
| Author: | CoreyJo [ Sun Mar 18, 2007 9:59 am ] |
| Post subject: | |
There's a good article by Chris on the BMC site. Here's a link to Chris' detailed steering wheel installation. Hopefully that helps. Good luck. http://www.bmcforums.com/showthread....steering+wheel |
|
| Author: | Dansgt [ Sun Mar 18, 2007 12:46 pm ] |
| Post subject: | steering wheel |
Dave the kind of puller i used it went behind the steering wheel not into any holes and had a center screw that you put a wrench on and tighten it that way and the steerin wheel popped off. i still have the pulled from my work i'll drop of to your work tomorrow if you still have any problems. let me know  . i can drop it off at the front desk.
|
|
| Author: | gtvert01 [ Sun Mar 18, 2007 12:51 pm ] |
| Post subject: | |
Thanks Corey but he doesn't show the wheel coming off. I PM'd him. Thanks Dan. I appreciate it. I'll be around if not just leave it at the front desk. That is the kind they called for in my F-150 manual. |
|
| Author: | Rick Hinkle [ Tue Mar 20, 2007 3:20 pm ] |
| Post subject: | |
Dave, I have several of the claw-type pullers in various sizes. If you don't have the size you need, just yell and you can borrow one. |
|
| Author: | gtvert01 [ Tue Mar 20, 2007 3:26 pm ] |
| Post subject: | |
Thanks. I also got a tip from someone. They said that after you crank it down pretty well give that large center screw a quick shot with a hammer and sometimes that pops them off. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|